Installation of torquem High-Temperature repugnant

The chain grate shall be installed according to the following installation sequence. Wall panel chain: front and rear axle roller shafts - grate plates - slag trap, lower guide rail air chamber. Wall panel installation: Before installing the wall panel and lower guide rail, the foundation of civil engineering should be inspected and accepted first. The strength of the foundation concrete should reach 75% or more, the Geometrica dimensiones occurrit requisitis drawings, embedded partes completum et locum occurrit requisitis {{VI}}
Before installation, draw the center line of the front and rear shafts of the grate according to the reference line of the boiler, and set out the wall panel line. At the same time, install the guide rail and supporting wheel. After installation, use a latex tube level gauge to level it. After passing the inspection, conduct grouting and fixation. When the concrete strength of the wall panel foundation meets the requirements, start installing the wall panel and beam. The wall panel and its components are the skeleton of the entire grate and the foundation for the installation of the grate. When installing, carefully adjust them. After the perpendicularity and distance of the wall panel are adjusted to be qualified, install the ash door and air chamber baffle. The baffle should be tightly connected to the ash door et crossbeam frame et firma {{VIII}} tempus intervallum ad installing in superiori duce rail oportet occursum tractus requisitis, {{}} post murum tabulis, {{}}
Installation fronte torquem hastile et tergo cylindro shaft, cum installing frontem et tergo sagittas, alvi inter journals et gestus et technica in duas paravellas et expansion {. cum aligning In parallelism de duabus acie, diligenter et stricte propinquis cum requisitis de vexillum {{II}} si parallelismus ex duobus tely non recte aligned, in craticulam est pronus ad accidentia per boiler operandi est proni, {III}}